boats specifications

add to favorites

Year : 2005 , Length : 40 ft 3 in LOA ,

Details:

2005 Beneteau First 40.7 boats specifications
read comments (-)	\|	add comments

Year

2005

Length

40 ft 3 in LOA

# of Engines

Beam

12 ft 5 in

Boat Description

The most successful 40 footer of its time, this best-seller is equally at home racing at high-level or out on family cruise.

Boat Designer

Farr Yacht Design

Cabin Accommodation

- OWNER’S CABIN FORWARD - • Headroom: 1.90m. • Spacious passage. • Double berth 2m x 1.60m at the shoulders. • Hanging locker. • Shelving along hull. • Reading light at head end. • Deckhead light. • Lewmar 440mm x 440mm opening hatch with blind. - SALOON - • Headroom: 1.95m. • Oval settee with high-density foam seat and backrest. • Stowage spaces behind settee backrests. • Inlaid saloon table. • Bar unit near settee to starboard. • Shelving. • Handrails with built-in blinds. • Plenty of natural light by means of: • Lewmar 440mm x 440mm opening hatch with blind. • Two fixed hull ports. • Four deckhead lights with independent switches. - TWO AFT CABINS - Each cabin comprises: • Double berth 2m x 1.50m. • Mattress in two parts. • Hanging locker. • Shelving along the hull. • Stowage under the berth. • Access hatch to aft compartment. • Oddments locker at head end of berth. • Deckhead light. • Lewmar opening port to cockpit.

Cockpit

• Teak slatted cockpit seats. • Removable stowage locker aft to starboard. • Gas locker aft to port. • Liferaft stowage to aft of cockpit under teak slatted helm seat. • Steering wheel column. • Teak grating for helm. • Emergency tiller. • Steering compass on column. • Navigation electronics (see specifications below). • Self-draining cockpit. • 2 waterproof cockpit speakers. • Outboard motor bracket on pushpit.

Dashboard

Deadrise at Transom

Deck

The deck is balsa sandwich construction (glass fibre, balsa, polyester resin) for an optimal strength/weight ratio and for good thermal and sound insulation. A roughened non-slip surface increases safety over all areas of movement on deck. An inner deck moulding is sealed to the deck to round off the finish. - MOORING AND ANCHORING - • Stainless steel bow fitting. • Tack fitting and removable bow roller. • 6 aluminium mooring cleats with stainless steel protection. • Self-draining anchor well with hatch cover. • 12V 800W horizontally mounted electric windlass with up and down controls. - BATHING PLATFORM AND AFT DECK - • Teak slatted bathing platform. • Stainless steel removable bathing ladder with teak treads. • White transom. • Hot and cold cockpit shower. • 220V shore supply socket..

Draft Board/Drive Up

Dry Weight

15211.88 lb Light Displacement

Electrical

Supply and management: • 1 x 70 Amp 12V engine battery with circuit breaker. • 1 x 110 Amp 12V service battery. • Battery management by voltmeter. • 20 Amp battery charger. • 16-switch 12V electrical panel and breaker. • 220V supply. • 2 x 220V sockets. • Lighting (see Accommodation). Navigation lights: • 1 bicolour bow light. • 1 white stern light. • 1 anchor light.

Engine

Inboard

Engine Mechanical

• 38 hp Sail Drive engine. • Engine compartment insulated and sound-proofed with honeycomb foam. • Rotomoulded fuel tank of approx. 135L capacity with sediment filter and cut-off. • Engine hatch in cockpit to port. • Flush aluminium engine control lever.

Engine Notes

Flybridge

Fuel

Fuel Capacity

36.46 gal

Galley

• Rectangular double stainless steel sink with mixer tap. Hot and cold pressurised water. • Gimballed 2-burner hob and oven. • 90L 12V refrigeration unit. • Cutlery drawer. • Waste bin. • Under-sink stowage and shelf units. • Three-compartment galley stowage unit with doors. • Dustpan in sole. • Two deckhead lights. • Lewmar 174mm x 304mm opening port.

General Construction

Horsepower (total)

Hull

• The hull is single-skinned laminated GRP. • A structural inner moulding formed with unidirectional fabric is bonded and laminated to the hull. Its structural role is important as it takes and absorbs the stresses at pressure points (chain plate tie rods, keel, rudder etc.) and spreads any loads, guaranteeing reduced strain on the hull. The surface to the inner hull makes it easier to clean and provides a better finish. • The hull gel coat is grey in colour.

Hull Material

Fiberglass

Hull Shape

Monohull

Hull Warranty

Length at Waterline

Load

Max Bridge Clearance

Max Draft

Max Seating Capacity

Number of Berths

Number of Heads

Principal Features

Safety Equipment

• Stainless steel pulpit. • Bicolour navigation lights fitted to pulpit. • Stainless steel pushpit in two parts with lifebuoy holder, ensign staff support and closing guardrail. • A double row of adjustable stainless steel guardrails surrounds the boat.. • 8 stainless steel shaped stanchions with flush moulded stainless steel bases (B�n�teau patent). • Teak toerails surround the deck. • Two stainless steel handrails bolted to the coachroof.

US specification includes

Water Capacity

71.86 gal

go to top

» All Beneteau

RECOMMENDED IN THIS CATEGORY

» 2005 First 31.7

» 2005 First 44.7

» 2005 50

» 2005 First 25.7

» 2005 57

» 2005 Oceanis Clipper 343

» 2005 25 Platu 2000

» 2005 First Class 7.5

» 2005 First 40.7

» 2005 Océanis Clipper 331

» 2005 Océanis Clipper 423

» 2005 Océanis Clipper 473

» 2005 Figaro II

» 2005 Oceanis Clipper 523

» 2005 Océanis Clipper 373

» 2005 Océanis Clipper 393

» 2005 Cyclades 43

» 2005 First 47.7

» 2005 Océanis Clipper 42 CC

» 2005 First 36.7

Beneteau

NOTE: On this page you will find ONLY boats specifications specifications and details. We don`t sell this product.
boats specifications	Site Map \| Contact Us \| ^^^

2005 Beneteau First 40.7 boats specifications