This 12 meters is concentrated cruising. Fast and easy to handle, she is an invitation to blue water cruising. 2 interior versions.
2 and 3 cabin versions are available.
Pivoting helm seat allows easy access to bathing platform (B�n�teau patent).
Sail locker to port.
Liferaft locker to starboard.
Locker for 2 gas bottles to port.
2 aft cockpit lockers.
All cockpit benches are teak-slatted.
Steering wheel console holds navigation
Steering compass on console.
Control lever on cockpit coaming to starboard.
1 x 12 V cigarette lighter socket on console.
Folding varnished wood cockpit table fixed to steering wheel console.
Manual bilge pump.
Deadrise at Transom
The deck is a balsa sandwich construction for an optimal strength/weight ratio and for good thermal and sound insulation.
- MOORING AND ANCHORING -
Welded stainless steel bow fitting with offset bow roller for anchor stowage.
4 aluminium roller fairleads on toerail. There are 2 roller fairleads between the bow fitting and the toerail.
6 x 300mm aluminium mooring cleats.
Main anchoring kit has 1 flat 16 kg, anchor, 1 x 25m chain and 38m warp (4 mooring lines and 6 white fenders).
800W 12V electric windlass with waterproof relay housing and on-deck up/down switches assisting anchor handling.
Self-draining anchor well with hatch cover.
- BATHING PLATFORM AND TRANSOM -
Transom with teak covered bathing platform and sliding access gate.
Stainless steel bathing ladder with teak treads and a handrail.
Outboard motor bracket.
Protective rubber rubbing strake.
Cold water cockpit shower.
Draft Board/Drive Up
17151.94 lb Light Displacement
12-switch 12V electrical panel plus 3 x 220V switches.
Cigarette lighter socket.
Double protection to electrical panel, differential circuitbreaker and bi-polar temperature magneto for the 220V
circuit and 12V magneto temperature circuit breaker.
The 12V electrical circuit is supplied by:
1 x 140 Amp service battery.
1 x 110 Amp engine battery.
Resource management indicators:
Battery charge warning light.
Battery charging by coupling to engine alternator or 220V 20 Amp shore supply.
Lighting and sockets:
1 waterproof 30 Amp shore supply socket.
Approved navigation lights.
Bow and stern navigation lights.
Steaming light (masthead light)
Foam sound-proofed engine compartment.
Engine control panel with rev. counter and alarms on starboard cockpit coaming with Perspex protection.
Stainless steel propeller shaft with GRP protection moulded into the hull.
Fixed 3-blade propeller.
Engine control lever on steering console.
Engine mounting built into the inner mould.
Rotomoulded 135L diesel tank aft, fitted with electronic gauge.
Salt water and diesel filters with sediment reservoirs.
A functional space:
- Stowage under hob with hinged door.
- Laminated work surface over icebox and
around sink with moulded wood fiddle.
- Stainless steel double rectangular sink.
- Mixer tap with hot/cold pressurised water.
- Stainless steel gimballed two-burner gas hob and oven with protective stainless steel safety rail.
- 90L GRP top opening icebox and 90L front
opening icebox with refrigerating unit.
- Seawater foot pump and icebox drainage.
- 220V socket.
- Stowage under hob with hinged door.
- Cutlery drawer.
- 3 shelves with slotted doors for ventilation.
- Cupboard with waste bin under sink.
2 halogen deckhead lights.
10 place settings.
The hull is a single-skinned GRP construction.
A structural inner moulding is bonded and laminated to the hull at various points. Its structural role is important as it takes and absorbs the stresses at pressure points
(chain plate tie rods, keel, rudder, etc.) spreading the loads and so guaranteeing reduced stress on the hull.
The surface of the inner moulding makes cleaning easier and provides a better finish.
The propeller shaft is protected by a moulding in the hull.
The hull is white with blue and gold decoration. A steel blue colour option is also available.